Protecta FIRST 100% Tie-off Lanyard

The Protecta AE57630 Shock Absorbing “Y” Lanyard is designed to enable 100% tie-off. The lanyard consists of two 1-3/4” web leg sections with each having a AJ523A (.8” capacity) double-locking snaphook attached. To use, attach one leg to an anchor point and move until an obstacle is encountered, then secure the second leg to the other side of the obstacle, release the first leg, and proceed. The shock absorber will activate when a force of approximately 675 lbs. is applied, and will continue as long as the force of fall arrest meets or exceeds this value. Max. extended length is 42”. If the unit becomes fully extended, a polyester strap is incorporated into the device to act as a 100% back-up strap.

Construction:

Web : 1.75” polyester. Minimum tensile strength greater than 5,000 lbs.

Hooks : AJ523A Zinc plated stamped steel

Net Weight 2.72 lbs.

Compliance - Meets or exceeds OSHA 1926 & ANSI Z359.1-1998 performance criteria

If your anchor points are over 3/4 in. in diameter, you may want to look at our rebar snap equipped lanyards. The FIRST 100% Tie-off Rebar Lanyard has hooks that will fit over anchor points up to 1-3/4 in. diameter.