Home > RAE Systems Gas Monitors > RAE Systems Gas Detectors > QRAE Plus Parts & Accessories > External Filter 10/PK

RAE Systems External Filter 10/PK

Item No: RAE01-008-3022-010

(1 review)

The Water Trap Filter is made of PTFE Teflon membrane with a 0.2 micron pore size to prevent water from being sucked into the sensor manifold of your RAE Systems gas monitor. It will also prevent dust and other particles from entering the monitor, thereby prolonging the operating life of the sensors.

To install the water trap filter, twist it tightly into the Luer connector on the inlet probe.

If the water trap filter changes color, traps dust or other particulates inside it, or if water has been sucked in, the filter needs to be replaced.

The water filter should not be used for some of the gases that could be absorbed by the filter material. These gases include: CL2, PH3, NH3, and HCN.

Packed and sold by the pack of 10.

Part Number:

008-3022-010

Overall Rating for External Filter 10/PK

(based on 1 review)

Too expensive, no other options.

By A J Taylor LLC from Salt Lake City, UT on January 18, 2012

They are needed to protect the pump but when you go thru 2 filters a day per monitor, with up to 10 monitors running, it gets expensive. They cost $0.10 each to manufacture.

Pros:

Simple, they do the job.

Cons:

Cost.

Merchant Response:

Thanks for your review. We appreciate your taking the time to send us your feedback. We agree with you: RAE Systems charges too much for these.

Unfortunately there just isn't any alternative out there for the RAE Systems monitors. You can save about 20% if you are willing to buy the bulk pack - http://www.pksafety.com/exfi10.html

Thanks again,

Ben
PK Safety Customer Service